hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing a Processor
Chapter 2
79
4. Use the special processor tool shipped with your replacement processor assembly to
lock the processor in place on the system board. To do this, insert the special
processor tool into the hole that runs down the side of the heatsink and rotate it
clockwise 180 degrees. Then, slide the sequencing retainer plate toward the front of
the system. Next, screw in the four heatsink captive screws. See Figure 2-64.
Figure 2-64 Screw in the Heatsink and Processor Screws
5. Connect the power cable for the processor’s turbo fan to its connector on the system
board. See Figure 2-59.
6. Slide the power module on the system board’s metal mounting bracket so that the
power modules connector connects with its connector on the processor. The two
mounting screw holes on the power module must align themselves with their screw
holes on the system board’s metal mounting bracket. Screw in the power module’s
mounting screws. See Figure 2-57.
7. Replace the airflow guide and connect the power module’s power cable (refer to steps
three through six of the instruction on page 69).
8. Verify that the processor works by turning the system on and executing the info cpu
command at the Extensible Firmware Interface’s prompt. For details on the info
cpu command, read the chapter “System Configuration” in this document.
Captive ScrewTurbo Fan
Heatsink
Special Processor
Tool
Sequencing
Retainer Plate