hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing the System Board
Chapter 2
81
5. Unscrew the six backplane system board mounting screws that connect the system
board to the rear of the system chassis. See Figure 2-66.
Figure 2-66 Unscrewing the Six System Board Mounting Screws
6. Disconnect all cables that are connected to the system board. Note that there are
three cables located near the system’s PCI/AGP cage that need to be removed. These
cables can be accessed only by lifting up the connector bridge for the PCI/AGP cage’s
fan. See Figure 2-67. To help with re-assembly, make note of which cables were
connected to which connector.
Figure 2-67 Disconnect the Three Cables under the Connector Bridge
System Board
Mounting Screws
System Board
Mounting Screws
Three Power Cables
Connector Bridge