hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing the System Board
Chapter 2
84
Replacing the System Board
To replace the system board, follow these steps:
1. Complete all of the steps in the section “Removing the System Board” on page 80. If
you have already completed the steps in the section “Removing the System Board,”
then skip to step two.
2. Grasp the new system board by its edges and carefully place it in the system. Angle
the system board as shown in Figure 2-71 to allow the PCI connector to slide into the
PCI/AGP cage bay area. Remember that the system board keyholes must be aligned
with their corresponding standoffs on the system’s chassis. Also, the PCI connector
posts on the system board must slide into their slots on the system chassis. See
Figure 2-71.
Figure 2-71 Replace the System Board in the System
3. Slide the system board back toward the rear of the system. This secures the system
board on its standoffs. See Figure 2-72.
Figure 2-72 Secure the System Board on Its Standoffs
PCI
Connecto
r
Slots
PCI
Connecto
r
Posts
System Board