hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing the System Board
Chapter 2
86
6. Screw in the six rear backplane system board mounting screws. See Figure 2-66.
7. Complete this step if you system does not have a Management Card. Replace the
power connectors in their slots on the back of the system and screw in the power
connector mounting screws. See Figure 2-65.
8. Follow these steps:
a. Complete steps five and seven of the section “Replacing/Installing the
Management Card” on page 72. You can skip this step if your system does not
have a Management card.
b. Complete steps three through five of the section “Replacing the Processor Airflow
Guide” on page 69. Note that you will need to route the processor’s power module
cable through the cable clips on the airflow guide.
c. Complete step three of the section “Replacing a System Fan” on page 66.
d. Complete step seven of the section “Replacing an Accessory Card” on page 51.
e. Complete the reverse of step three of the removal instructions found in the
section “Removing and Replacing Memory” on page 46.
9. Replace the system’s access panel(s) (refer to page 37 or page 41). Reconnect all of
the power and external cables.
10. Verify that the processor works by turning the system on and executing the info cpu
command at the Extensible Firmware Interface’s prompt. For details on the info
cpu command, read the chapter “System Configuration” in this document.