hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing the System Batteries
Chapter 2
87
Removing and Replacing the System Batteries
The section explains how to remove and replace the system batteries. Note that there are
two batteries in the system if you have a Management card installed, otherwise, there is
one battery in the system.
Removing the System Board’s Battery
To remove the system board battery, follow these steps:
1. Turn off the system and disconnect all power and external cables.
2. Remove the system’s access panel(s) (refer to page 37 or page 41 for instructions).
3. Complete steps three through five of the section “Removing the Processor Airflow
Guide” on page 67.
4. Lift up on the battery with a finger and push on the back of it with a small flat-head
screwdriver. This will remove the battery from its holder. See Figure 2-74.
CAUTION You should lift the battery just high enough to clear its holder because too much
stress on the battery holder’s retaining clip could break it.
Figure 2-74 Remove the System Board’s Battery
System Board Battery,
Retaining Clip and
Battery Holder (plus
+
side or battery is up)