hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing the Power Supply Interface Module
Chapter 2
91
Replacing the Power Supply Interface Module
To replace the power supply interface module, follow these steps:
1. Insert or place the power supply interface module into the system’s chassis. To do
this you will need to slide the power supply interface module’s retaining tab into its
retaining slot located on the hard disk drive bay area wall. See Figure 2-78.
Figure 2-78 Replacing the Power Supply Interface Module
2. Screw in the power supply interface module’s mounting screw and secure the power
cables behind their holding clips. See Figure 2-79.
Figure 2-79 Securing the Power Supply Interface Module and Its Cables
3. Complete steps two through nine of the section “Replacing the System Board” on
page 84.
Retaining Tab
Retaining Tab Slot
PSI Mounting Screw
PSI Power Cable