hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing the Hard Drive Backplane
Chapter 2
92
Removing and Replacing the Hard Drive Backplane
The section explains how to remove and replace the hard drive backplane. The hard
drive backplane provides connectors for three hard disk drives.
Removing the Hard Drive Backplane
To remove the hard drive backplane, follow these steps:
1. Turn off the system and disconnect all power and external cables.
2. Remove the system’s access panel(s) (refer to page 37 or page 41 for instructions).
3. Complete step three of the section “Removing an Accessory Card” on page 49.
4. Lift up on the fan power bridge and disconnect the backplane power cable. See
Figure 2-80.
Figure 2-80 Disconnect the Fan and Backplane Power Cables
5. Disconnect the SCSI cables and unscrew the backplane mounting screws. See
Figure 2-81.
Figure 2-81 Unscrewing the Backplane’s Mounting Screws
+
Fan Power Bridge
Backplane Power Cable
SCSI Cables
Backplane Mounting Screws