hp workstations zx6000, hp server rx2600 - operation and maintenance guide

Installing or Replacing Parts and Accessories
Removing and Replacing the Hard Drive Backplane
Chapter 2
93
6. Remove the hard drive backplane by sliding it in the direction of the arrow and
pulling it outward from its standoff posts. See Figure 2-82.
Figure 2-82 Remove the Hard Drive Backplane
Replacing the Hard Drive Backplane
To replace the hard drive backplane, follow these steps:
1. Insert the hard drive backplane onto its four chassis standoffs and slide it to the left
as you face it. This locks the hard drive backplane in place. See Figure 2-82.
2. Screw in the two backplane mounting screws and connect the two SCSI cables. See
Figure 2-81.
3. Connect the backplane power cable and lower the fan power bridge until it snaps in
place. See Figure 2-80.
4. Complete step seven of the section “Replacing an Accessory Card” on page 51.
5. Replace the system’s access panel(s) (refer to page 37 or page 41). Reconnect all of
the power and external cables and turn on the system.
Slide the Backplane in Direction of Arrow
Backplane