Internal Cabling Guide for NetRAID-2M on an HP Server rx2600[HP S&C DVD 1.03]

Figure 11: Disconnecting the Management Card Connector and
Removing the Card
9. Disconnect and remove any unused SCSI cables from the system board as shown in
Figure 12.
Figure 12: Disconnecting Unused SCSI Cables from the System
Board
For single channel support, plug one end of the A7231-63019 single channel cable
into the HP NetRAID-2M card's internal channel 0 (CH 0) connector (see Figure 13).
The cable connectors are marked for clarity. Note that part of the cable must be folded
down (90 degrees) as shown in Figure 13. Make sure it lies flush against the HP
NetRAID-2M card to prevent it from obstructing the access to other PCI slots, with
the other part of the cable exiting the PCI cage flush against where the PCI board
cover and cable channel will fit on the PCI cage (see Figure 15).
Do not reinstall the PCI cage or plug the other end of the cable into the hard drive
backplane yet. This will be described later.
11
HP CONFIDENTIAL Codename: Longs Peak Part Number: 5971-4217 Last Saved On: 4/2/03 2:24 PM