Internal Cabling Guide for NetRAID-2M on an HP Server rx2600[HP S&C DVD 1.03]

CH0
90
0
Figure 13:
Single Channel RAID Cabling from the HP NetRAID-2M (Installed in the PCI
Cage)
For dual channel support, plug one end of the A7231-63007 dual channel cable into
the HP NetRAID-2M card's internal channel 0 (CH 0) and 1 (CH 1) connectors (see
Figure 14). The cable connectors are marked for clarity. Note that part of the cable
must be folded down (90 degrees) as shown in Figure 14. Make sure it lies flush
against HP NetRAID-2M card to prevent it from obstructing access to other PCI slots,
with the other part of the cable exiting the PCI cage flush against where the PCI board
cover and cable channel will fit on the PCI cage (see Figure 15).
Do not reinstall the PCI cage or plug the other end of the cable into the hard drive
backplane yet. This will be described later.
CH0
CH1
90
0
Figure 14:
Dual Channel RAID Cabling from the HP NetRAID-2M (Installed in the PCI
Cage)
10. Replace the PCI cage board cover routing the RAID cable out of the cover's cable
channel (see Figure 16). Note that the RAID cable should be folded down flush against
the HP NetRAID-2M card with the latter half of the cable bent in order to exit through
the PCI board cover cable channel (see 1 in Figure 15).
12
HP CONFIDENTIAL Codename: Longs Peak Part Number: 5971-4217 Last Saved On: 4/2/03 2:24 PM