Internal Cabling Guide for NetRAID-2M on an HP Server rx2600[HP S&C DVD 1.03]

Introduction

This document describes how to cable an HP NetRAID-2M 2 channel, Ultra160 accessory

(HP product number P7749A) to the internal hard drives of an HP Server rx2600.

NOTE: These instructions do not apply if you are connecting the HP NetRAID-2M to an external mass

storage box. Proceed to the HP NetRAID-1M and 2M Installation and Configuration Guide that shipped

with your HP NetRAID-2M accessory.

Before you begin, you will need:

• The two cables included in this kit (either the HP A7071A Internal NetRAID cables for

rx2600 kit or the HP P7749A NetRAID 2M card kit):

— Cable p/n A7231-63007 for dual RAID channel configuration

— Cable p/n A7231-63019 for single RAID channel configuration

• T-15 Torx driver

• 3/16-inch hex driver

• Cable securing clip, also included in this kit (p/n 1400-1675)

• HP P7749A NetRAID-2M card (see Figure 1)

Figure 1: The HP NetRAID-2M Accessory

HP CONFIDENTIAL Codename: Longs Peak Part Number: 5971-4217 Last Saved On: 4/2/03 2:24 PM