Internal Cabling Guide for NetRAID-2M on an HP Server rx2600[HP S&C DVD 1.03]

Recabling for RAID
Your server's internal hard disk drives may be set up for single or dual channel RAID
support. To use RAID with your server's internal hard disk drives, disconnect the internal
SCSI cable(s) from their controller and the hard disk drive backplane (described below).
Then connect the HP NetRAID-2M card to the hard disk drive backplane using either the
single channel cable or the dual channel cable that is supplied. Follow the instructions below
to accomplish these tasks.
1. To get access to the hard drive backplane and the internal SCSI cables, remove fans 2 and
3. Refer to Figure 7 for their location, then proceed to step 2 for removal instructions.
2
3
Figure 7: Location of Fans 2 and 3
2. To remove the fans, grasp the fan module that needs to be removed with your index
finger and thumb and lift it out of its fan slot. Note that each of the fan modules has
indentations for grasping them with your index finger and thumb. See Figure 8.
Figure 8: Removing Fans 2 and 3
3. To remove a SCSI cable, lift up on the fan power bridge as shown in Figure 9.
9
HP CONFIDENTIAL Codename: Longs Peak Part Number: 5971-4217 Last Saved On: 4/2/03 2:24 PM