Management Processor Card Firmware Upgrade Product Update - HP integrity rx2600 and HP integrity rx5670

Management Processor Card Firmware Upgrade
Introduction
Chapter 2
11
2 Management Processor Card Firmware
Upgrade
Introduction
This document is intended to provide information on the supported operating environment for MP and to
provide installation instructions for upgrading the MP Processor Card Firmware to the latest release:
• The procedure for determining your current Management Processor Card Firmware version is described.
• The procedure for upgrading the MP Processor Card Firmware is explained.
• The procedure for setting up and using SSL is described.
Determining the Firmware Version
Please review all instructions and the Hewlett-Packard Support Tool License Terms, or your Hewlett-Packard
support terms and conditions for precautions, scope of license, restrictions, and limitation of liability and
warranties, before installing this patch.
It is important that you read and understand these instructions completely before you begin. This can
determine your success in completing the Firmware update.
CAUTION The MP Card firmware upgrade process can only be done using an FTP site. For example, if the
currently installed firmware is older than E.02.10, then updating to GSP firmware revision
E.02.22 requires updating to E.02.10 first.
Finding the Current Firmware Version
The current version of the firmware must be E.02.10 or greater before this upgrade may be applied. If your
firmware is older than E.02.10, apply the E.02.10 firmware upgrade first before applying any other upgrade.
To find the current version of your firmware, complete the following steps:
Step 1. Establish a telnet session with the Management Processor.
Step 2. Log on to the Management Processor using the Admin password.
Step 3. Type ^Ecf to get console write access, where ^E = CTRL key + e are pressed simultaneously.
Step 4. Type ^b to enter the Management Processor, where the CTRL key + b are pressed simultaneously.
Step 5. Type HE at the MP> prompt.
A line similar to the following is displayed.
Hardware Revision e1 Firmware Revision E.02.20