Operations and Maintenance Guide, Second Edition - HP Integrity rx2600 Server and HP zx6000 Workstation

HP Integrity rx2600 server and HP workstation zx6000 Operation and Maintenance Guide C–161
System Board
■ Three I
2
C master/slave ports (one of the ports is used for Intelligent platform management
bus (IP MB))
■ Low pin count (LPC) bus provides access to three keyboard controller style (KCS) and
one-block transfer (BT) interface
■ 32-bit ARM7 RISC processor
■ 160-pin low profile flat pack (LQFP) package
■ Firmware is provided for the following interfaces:
❏ IPMI
❏ IP MB
SCSI Controller
The SCSI controller is an LSI Logic 53C1030 chip. This chip is fully compliant with the SCSI
Peripheral Interface-4 Specification (SPI-4). It has two independent SCSI channels supporting
devices at speeds up to 320 MB/sec each.
IDE Interface
The IDE interface provides support for an internal CD-RW or a DVD reader through an internal
IDE connector and cable. This interface supports the master capability.
The IDE controller (PCI649) supports the ATAPI zero (0) to five (5) modes (from 16 to 100
MB/s). The usable speed on this system is limited to 16MHz (ATA-33 mode, 33 MB/s) because
the slimline CD/DVD devices do not support the ATA-66 and 100 modes.
The primary IDE channel is the only channel that is implemented. The IDE cable provides only
one drive connector, of the master type, for the optical storage peripheral.
10/100 BT Management LAN
The 10/100 BT LAN port provides the following:
■ Basic remote manageability features on the core system.
■ A management LAN interface for operating system level manageability applications such as
Toptools.
■ The LAN controller is an Intel 82550 chip.
■ Power-On-LAN is an additional feature that the LAN controller provides. Power-On-LAN
allows you the ability to power up a system remotely through the LAN by sending special
LAN packets to the system to be powered on.
1 GB System LAN
The 1 GB system LAN provides the following:
■ Main system LAN
■ 10/100/1000 Mb capable