Operations and Maintenance Guide, Second Edition - HP Integrity rx2600 Server and HP zx6000 Workstation

70 HP Integrity rx2600 server and HP workstation zx6000 Operation and Maintenance Guide
Removing and Replacing Components
To replace the top cover, follow these steps:
1. Align the front edge of the top cover with the alignment mark on the optical drive bay.
Top Cover Alignment Mark
2. Grasp the blue release lever and slide the top cover toward the front of the server until the
lever snaps into place.
Replacing the Top Cover
3. Slide the server into the rack enclosure and reconnect the power cables.
Removing the Front Bezel
You must remove the front bezel from the chassis to upgrade, remove, or replace the power
supplies or the optical drive.
To remove the front bezel, follow these steps
1. Press in on the retaining clips located on the right-side of the front panel.
Retaining Clip
2. Rotate the front panel outward and lift it off the server chassis.
Replacing the Front Bezel
To replace the front bezel, follow these steps
1. Insert the bezel latches into the matching slots on the server chassis.
2. Close the bezel and push toward the front of the server until it snaps into place.