Operations and Maintenance Guide, Second Edition - HP Integrity rx2600 Server and HP zx6000 Workstation

86 HP Integrity rx2600 server and HP workstation zx6000 Operation and Maintenance Guide
Removing and Replacing Components
❏ On servers with firmware version 2.0 or higher, check the configuration using the EFI
System Configuration menu.
NOTE: Ensure that the audio cable is properly installed by connecting headphones to the audio
OUT jack on the audio card and playing audio media in the optical device.
Removing and Replacing the PCI/AGP Backplane
The backplane for the zx6000 includes one AGP card slot and three PCI card slots. The rx2600
server backplane is called the PCI/AGP backplane. The removal process is the same for both.
Removing the PCI/AGP Backplane
To remove the PCI/AGP backplane, follow these steps:
1. Remove all accessory and graphics cards.
2. Unscrew the backplane mounting screws and slide the backplane board toward the bulkhead
end of the PCI/AGP cage. This unlocks the backplane from its standoffs.
3. Lift the backplane over the top of the standoffs and slide it out of the cage.
CAUTION: Be careful not to damage the intrusion switch.
Removing the PCI/AGP backplane (rx2600 shown)
Replacing the PCI/AGP Backplane
To replace the PCI/AGP backplane, follow these steps:
1. Place the backplane in the cage by aligning the cage standoffs with the holes on the
backplane and slide it into place.
2. Secure the PCI/AGP backplane by screwing in its mounting screws.