Operations and Maintenance Guide, Second Edition - HP Integrity rx2600 Server and HP zx6000 Workstation

88 HP Integrity rx2600 server and HP workstation zx6000 Operation and Maintenance Guide
Removing and Replacing Components
Removing the Optical Drive
Replacing an Optical Drive
To replace an optical drive, follow these steps:
1. Slide the optical drive into the drive bay until it stops sliding and the retaining clips on both
sides of the optical drive snap into place.
Grasp both sides of the drive without pressing in on the retaining clips and pull outward. If
you can pull outward on the optical drive without it sliding out of its bay, the optical drive is
securely in place.
Replacing the Optical Drive
2. Connect the IDE cable on the back of the optical drive.
3. Replace the server covers, reconnect all of the power and external cables and power on the
server.
4. Verify that the optical drive has been properly installed:
❏ Run the info io command at the EFI shell prompt or,
❏ On servers with firmware version 2.0 or higher, check the configuration using the EFI
System Configuration menu.
Removing and Replacing the iLO MP Card
The optional iLO MP card includes these ports: