Tower to Rack and Rack to Tower System Conversion Guide

Converting a Tower System to a Rack System

Process for Converting Your Tower System to a Rack System

Step 6: Installing the System’s Right Front Access Panel

To install the rack system’s right front access panel, position the panel at approximately

45 degrees to the front of the system and place the panel’s retaining slots onto the

chassis retaining tabs. Rotate the panel inward until its retaining clips snap in place.

See

Figure 1-15.

Figure 1-15 Installing the Right Front Access Panel

Retaining Tabs

Retaining Clips

Retaining Slots

Front Access Panel

Step 7: Installing the System in its Rack Enclosure

To complete the installation of the rack system in the rack enclosure, follow the

instructions in the document Installation Guide for Midweight Slide Kit (HP Part

Number: 5064-9640) that is shipped with your rack installation kit.

Chapter 1