Tower to Rack and Rack to Tower System Conversion Guide

Converting a Rack System to a Tower System
Process for Converting Your Rack System to a Tower System
Step 2: Removing the System from its Rack Enclosure
To remove a rack system from its rack enclosure, reverse the instructions in the
document Installation Guide for Midweight Slide Kit (HP Part Number: 5064-9640) that
was shipped with your rack installation kit.
Step 3: Removing the System’s Front Access Panel
To remove the rack system’s front access panel, press in on the front access panel’s
retaining clips (located on the right side of the system) and rotate the front panel
approximately 45 degrees away from the system’s chassis. Next, disconnect the front
access panel’s retaining slots from their retaining tabs on the system’s chassis. See
Figure 2-1.
Figure 2-1 Remove the Front Access Panel
Retaining Tabs
Retaining Clips
Retaining Slots
Front Access Panel
Chapter 2
17