Tower to Rack and Rack to Tower System Conversion Guide

Converting a Rack System to a Tower System
Process for Converting Your Rack System to a Tower System
2. Place the top access panel on the system’s chassis, press downward and slide the top
panel toward the front of the system until it snaps into place. See Figure 2-14.
Ensure that all hooks are in place.
Figure 2-14 Slide the Top Access Panel onto the System’s Chassis
Top Panel
Front of
System
3. Position the left-side access panel at an approximate 45 degree angle with the left
side of the system and insert its retaining slots on their retaining tabs, which are
located on the pedestal. See
Figure 2-15. Rotate panel inward until it snaps in place.
Note that the right-side access panel is installed in this same manner.
Figure 2-15 Install the Left-side and Right-side Access Panels
Pedestal
Retaining Slots Retaining Tabs
Chapter 2
25