Tower to Rack and Rack to Tower System Conversion Guide

Preface
Important Warnings
Avoid Electrical Shocks
WARNING To avoid electrical shock, do not open the power supply. There are no
user-serviceable parts inside.
To avoid electrical shock and harm to your eyes by laser light, do not open the
laser module. The laser module should be serviced by service personnel only.
Do not attempt to make any adjustment to the laser unit. Refer to the label on
the CD-ROM for power requirements and wavelength. This product is a class I
laser product.
Electrical
WARNING For your safety always connect the equipment to a grounded wall outlet.
Always use a power cord with a properly grounded plug, such as the one
provided with the equipment, or one in compliance with your national safety
standards. This equipment can be disconnected from the power by removing
the power cord from the power outlet. This means the equipment must be
located close to an easily accessible power outlet.
Removing And Replacing The Cover
WARNING You can remove system covers to remove or replace hot-swappable devices,
such as hard disk drives, optical drives and fans. However, when removing
components other than hot-swappable devices, never remove the system cover
without first disconnecting the power cord from the power outlet and
removing any connection to a telecommunications network. Always replace
the cover before switching the system on again.
CAUTION Both the zx6000 and rx2600 systems depend on the system cover for proper cooling of
internal components. Operating the system with the system cover removed, can cause
the system to quickly overheat.
Static Electricity
CAUTION Static electricity can damage electronic components. Turn OFF all equipment when
removing or adding components. Don’t let your clothes touch the accessory. To equalize
the static electricity, rest the accessory bag on top of the system while you are removing
the accessory from the bag. Handle the accessory as little as possible and with care.
3