Tower to Rack and Rack to Tower System Conversion Guide

Converting a Tower System to a Rack System
Process for Converting Your Tower System to a Rack System
2. Use the indentations located on the top edge of the left-side access panel and pull
outward to un-snap and rotate it away from system. See Figure 1-1. After an
approximate 45 degree rotation, lift the left-side panel upwards and off of the two
lower retaining tabs. Note that the right-side access panel is removed in this same
manner.
Figure 1-1 Removing the Left-side and Right-side Access Panels
Pedestal
Retaining Slots Retaining Tabs
3. Rotate the blue release handle toward the back of the system and slide the internal
panel in the direction of the arrow. See Figure 1-2 a. Next, lift the access panel off of
the system’s chassis. See
Figure 1-2 b.
Figure 1-2 Removing the Internal Access Panel
a. Slide Access Panel
b. Lift Access Panel off of
in the direction of arrow
the system’s chassis
Chapter 1
7