Windows Integrity nPartition Guide

nPartition Commands Reference
parstatus
Chapter 5
125
-C Show information for all the cells in the complex.
-I Show information for all I/O chassis in the complex.
-B Show information for all cabinets in the complex.
-P Show information for all nPartitions in the complex.
-c cell
Show information about the specified cell.
-i IOchassis
Show information about the specified I/O chassis.
-b cabinet
Show information about the specified cabinet.
-p partition
Show information about the specified nPartition.
-u username:[passwd]
Specifies the account and authorization to access an nPartition other
than the local nPartition.
The -h option is required if this option is used.
• username specifies a configured user name on the target nPartition.
• passwd specifies the password associated with the username. If this
field is empty, the command prompts for the password.
-g [passwd] Allows access to the complex specified by the -h option. The accessed
complex is then considered the target complex. Access is through the
management processor LAN port.
The -h option is required if this option is used.
passwd specifies the IPMI password of the management processor. If
this field is omitted, the command prompts for the password.
-h IPaddress|hostname
This option is only used in combination with either the -u or -g option.
IPaddress|hostname specifies the IP address or hostname of the
target nPartition (-u) or management processor (-g).
Example In the following example, you connect to the server’s management processor (MP) from
your management station to request status information about all of the nPartitions in
the complex (-P option). The MP IP number is 192.168.24.68, and the MP password is
“password”. Since you are connecting remotely using IPMI over LAN, you must include
the -h... -g... options.
Step 1. Open a command window on the management station (
Start > Run > type cmd > click OK).