Windows Integrity nPartition Guide

Troubleshooting
Error messages and corrective actions
Chapter 6
156
Table 6-2 Application Event Log messages
Message Cause Recommended Action
Operation failed. Request could not be
completed.
See additional information
in AEL.
Firmware error. System firmware failed to
perform the requested
operation.
Service processor error. MP firmware failed to
perform requested
operation.
The power-on request
could not be satisfied
because an N- power
condition would result.
There is insufficient
system power to service a
cell that was specified to
be powered on.
Add additional power
supplies or replace a
defective power supply.
The power-on request
could not be satisfied
because an insufficient
cooling condition would
result.
There is insufficient
system cooling to service a
cell that was specified to
be powered on.
Add additional fans or
blower units or replace a
defective fan or blower.
Timed out waiting for a
response.
Datagram was lost. Retry command or use a
management PC with a
more reliable connection to
the target MP or
nPartition.
Insufficient privilege to
perform the operation.
Requesting user does not
have permission to
perform the requested
operation.
Run the command as
Administrator or “root”.
Invalid user name. Username specified in the
request was not valid on
the target nPartition.
Use a valid username.
Operation is only
supported by the local
operating system.
The requested operation
can only be performed by a
provider running on the
nPartition. It cannot be
performed through the
MP.
Use the -u option with the
command.
Operation is not supported
by the firmware.
The system firmware does
not support the requested
operation.
Cannot perform the
request on this target
system. May require
updating the system
firmware.