HP Smart Array 5300 Controller User Guide

Upgrading and Replacing Options
For further instructions or clarifications regarding the software key installation
procedure, refer to the ACU 6.0 online help.
Using the Enabler Module
The connector for the RAID ADG Enabler Module is located at the corner of the
controller board near the array accelerator connector socket, as shown in Figure 8-14.
The module attaches to the controller board with the narrow tab (circled in
Figure 8-15) nearest to the corner of the controller board. This tab can be pressed
outwards during installation to allow the module to be more readily inserted into the
board. The clips at each end of the module fit into the slots on the board.
Figure 8-14: Location of the RAID ADG Enabler Module
connector on the Smart Array 5300 Controller board
HP Smart Array 5300 Controller User Guide 8-13
HP CONFIDENTIAL
Writer: Kimberly Koch File Name: i-ch8 upgrading and replacing options.doc
Codename: SilverHammer Part Number: 135606-006 Last Saved On: 3/13/03 1:59 PM