Installation Guide, Third Edition - HP Integrity rx2620 (August 2006)

Introduction
Server Overview
Chapter 1
16
Server Overview
The HP Integrity rx2620 server chassis is a 2U Electronics Industry Association (EIA) enclosure, which
mounts in any standard 19 inch EIA rack. All external cabling connects through the rear of the enclosure.
With the server installed in the rack, service access is enhanced by the use of chassis slides. It has bays to
accommodate 1 + 1 redundant, hot-swappable power supplies, accessible from the front of the product. There
are 3 low-profile hot swappable hard disk drives accessible from the front, and a slim-line optical drive for a
CD-R, CD-RW, DVD-R or DVD+RW. There are N + 1 redundant, hot-swappable system fans, all clearly
identified and easily accessible. System status indication, a power switch, system locator switch and LED are
located in the front within the bezel. There is also a system locator switch and LED in the back of the system
for easy identification in the rack. See Figure 1-1, Figure 1-2, and Figure 1-3 for front and back views of the
server.
Figure 1-1 HP Integrity rx2620 Server (front view)
Figure 1-2 HP Integrity rx2620 Server (front view with bezel removed)
Figure 1-3 HP Integrity rx2620 Server (rear view)
SCSI LVD/SE
Management Card
LAN Gb A
VGA
PWR
1
2
PWR
LAN Gb B
LAN 10/100
SERIAL A
SERIAL B
CONSOLE
MP
RESET
Automatic Internal SCSI Termination
WARNING Unplug all power cords from system before servicing
TOC
CONSOLE / REMOTE / UPS
USB