Installation Guide, Third Edition - HP Integrity rx2620 (August 2006)

Chapter 3

Installing Additional Components

Installing Internal Hard Disk Drives

To install a hard disk drive when the drive bay is locked, perform the following steps:

Step 1. Remove the top metal cover. See “Removing the Top Metal Cover” on page 35.

Step 2. Locate the Lock/Unlock lever located between the drive bay and the side of the server at the front

left side of the server. See Figure 3-6 for the lever location.

Figure 3-6 Lock/Unlock Lever

Step 3. Press down on the Unlock lever to disengage the drive lock.

Step 4. Remove the slot filler by pulling it out of the server. Figure 3-7 shows how to remove the slot filler.

Figure 3-7 Filler Removal from Slot

Front of server