Installation Guide, Third Edition - HP Integrity rx2620 (August 2006)

Chapter 3

Installing Additional Components

Installing Internal Hard Disk Drives

Step 5. Release the lock on the drive being installed and swing the drive ejection handle to the open

position.

Step 6. Slide the hard disk drive into the slot until it is nearly seated. Figure 3-8 shows the installation of a

hard disk drive.

Figure 3-8 Disk Drive Installation

Step 7. Close the drive ejector handle by pushing it inward until it clicks.

Step 8. At the disk bay lock, press down on the

Lock lever to re-engage the drive bay lock (if necessary).

NOTE If you want the drives to be accessible without removing the top metal cover, leave

the drive lock lever in the Unlock position.

Step 9. Install the top metal cover (if necessary) unless you are installing more components. See “Replacing

the Top Metal Cover” on page 36 if necessary.

Front of server