Installation Guide, Third Edition - HP Integrity rx2620 (August 2006)

Chapter 5

Connecting Cables

AC Input Power

The server can receive AC input from two different AC power sources. If two separate power sources are

available, you can plug the server into the separate power sources, increasing system reliability should one

power source fail. The power receptacles are located at the rear of the chassis. They are labeled PWR 1 and

PWR 2.

CAUTION Do not route data and power cables in parallel paths in close proximity to each other. The

suggested minimum distance that the data and power cables should be apart is 7.62 cm (3

inches).

The power cord has current flowing through it, which creates a magnetic field. The potential to

induce electromagnetic interference in the data cables exists, thereby causing data corruption.

You can install a maximum of two bulk power supplies (BPS) in the server. Installing two BPSs in the server

provides n+1 redundancy, meaning that if one BPS fails, there is another power supply to power the server.

You must promptly replace the failed BPS to restore n+1 functionality.

A minimum of one BPS is required to power the server. There is no n+1 capability in this case.

Power States

The server has three power states:

• Standby power

• Full power

•Off

Plug the power cord into the appropriate receptacle on the rear of the chassis to achieve the standby power

state; the front panel power button is not turned on. Full power occurs when the power cord is plugged into

the appropriate receptacle, and either the power is activated through the MP PC command, or the power

button is activated. In the off state, the power cords are not plugged in. Table 5-1 lists the server power states.

NOTE If the power restore feature is set to Always On through the MP PR command, the server may

automatically power on to the full power state.

Table 5-1 Power States

Power States

Power Cable

Plugged Into

Receptacle?

Power Activated through the

MP PC Command; or

Front Panel Power Button

Activated?

AC Voltage

Applied?

DC Voltage

Applied?

Standby power Yes No Yes No

Full powe r Yes Yes Yes Yes

Off No No No No