Installation Guide, Third Edition - HP Integrity rx2620 (August 2006)

Chapter 5
Connecting Cables
AC Input Power
59
Apply Standby Power to the Server
Perform the following steps to apply standby power to the server:
IMPORTANT If the server has one BPS, you must plug the power cable into the receptacle labeled PWR 1.
Step 1. Locate the appropriate receptacle on the rear of the chassis and plug the power cord into the
receptacle.
Step 2. Observe the following LEDs at two different intervals to ensure the server is in the standby power
state:
Interval One After you plug the power cord into the server, the bulk power supplies flash
amber and an amber light is present on the hard disk drives.
Interval Two Approximately 30 seconds later, the bulk power supplies flash green and the
amber light is still present on the hard disk drives. Standby power is on at this
point.
Power Cord Retention
The following procedure shows how to install the power cord retention clip onto the back of the server.
Step 1. Unscrew the two #3 screws on the server AC area. See Figure 5-1 for the screw locations.
Figure 5-1 Installing the Power Cord Retention Bracket
#3 screws