Installation Guide, Third Edition - HP Integrity rx2620 (August 2006)

Chapter 5
Connecting Cables
LAN
60
Step 2. Install the plastic clip through the rectangular slot on the power retention bracket, and pull it
through until the clip clicks into place. See Figure 5-2.
Figure 5-2 Power Retention Clip and Tie Wrap
Step 3. Install the power cord bracket onto the server using the screws you just removed.
Step 4. Take the AC cord tie wrap and wrap it around the circumference of the AC cord and through the
hole in the tie wrap, near the connector.
Step 5. Insert the tie wrap into the plastic clip. See Figure 5-2.
Step 6. Repeat steps 2 through 5 (skip step 3) to secure the second power supply power cord (if necessary).
LAN
The server has two LAN ports that can provide network connectivity. Figure 5-3 shows the available LAN
ports for the server.
Figure 5-3 Rear Panel LAN Ports
To enable general network connectivity for the server, follow these steps:
Step 1. Obtain valid IP addresses for each LAN port you plan to activate.
Step 2. Connect the LAN cable from an available LAN port into a live connection on the network.
SCSI LVD/SE
Management Card
LAN Gb A
VGA
PWR
1
2
PWR
LAN Gb B
LAN 10/100
SERIAL A
SERIAL B
CONSOLE
MP
RESET
Automatic Internal SCSI Termination
WARNING Unplug all power cords from system before servicing
TOC
CONSOLE / REMOTE / UPS
USB
LAN Gb A
10/100/1000 LAN
LAN Gb B
10/100/1000 LAN
iLO MP 10/100
LAN (optional)