Rack to Tower and Tower to Rack System Conversion Guide (June 2005)

Converting a Tower System to a Rack System

Process for Converting Your Tower System to a Rack System

Chapter 4

Figure 4-10 Inserting the Right-side Rack Latch Bracket’s Retaining Tab into Its

Slot

Step 4. Connect the right-side rack mounting bracket to the system’s chassis by screwing in its mounting

screws. See Figure 4-11.

Figure 4-11 Connecting the Right-side Rack Latch Bracket to the System’s

Chassis

Installing the System’s Right Front Access Panel

To install the rack system’s right front access panel, position the panel at approximately 45 degrees to the

front of the system and place the panel’s retaining slots onto the chassis retaining tabs. Rotate the panel

inward until its retaining clips snap in place. See Figure 4-12.

Bracket’s Retaining Tab

and Slot

Rack Latch Bracket

Mounting Screws