FC2143 and FC2243 4Gb PCI-X 2.0 Host Bus Adapters for Linux and Windows Installation Guide
2 Installin g the HBAs
This chapter describes how to install the FC 2143 and FC2243 HBAs.
•
Prerequisites, page 13
•
Recording reference numb ers, page 13
• Installing the H BA,page14
See your server documentation for additional installation instructions.
WARNING!
Disconnect thehost from the powersourcebeforeinstalling theHBA.Toreducethe risk of personal injury
from hot surfaces, allow the i nternal server or workstation components to cool before touching.
CAUTION:
Electrostatic discharge (ESD) can damage electronic components. Be sure you are properly grounded
before beginning this procedure, as described in Electrostatic discharge.
Prerequisites
Before you begin, ensure that you have:
• An optical multimode cable with an LC-style duplex connector
• An empty PCI-X slot
NOTE:
To ensure optimum I/O performance, insert the HBA into an empt y PCI-X slot running at 133 MHz.
Ensure that the PCI bus is not shared by another PCI card, which can decrease the PCI-X slot clock rate.
Recording reference numbers
Each HBA ships with a unique address identifier that is stored in flash memory. Fibre Channel industr y
standards issue two unique identifiers: worldwide port name ( W WPN) and worldwide node name
(WWNN), each of which is derived from the HBA’s IEEE address. Combined, the WWPN and W WNN
create theworldwide name (WWN), whichisan8-byteidentifier that uniquely identifies an HB A on a
Fibre Channel circuit. The W W N address and serial number are clearly marked on the HBA. Record
this information for future reference.
NOTE:
The WWN is a static identifier that cannot be changed.
FC2143 and FC2243 4Gb PCI-X 2.0 host bus adapters for Linux and Windows installation guide
13