HP Integrity rx2660 Server User Service Guide

To install the battery clip:
WARNING! Ensure that the system is powered off and all power sources have been disconnected
from the server prior to performing this procedure.
Voltages are present at various locations within the server whenever an AC power source is
connected. These voltages are present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to follow
ESD safety precautions can result in damage to the server.
The following procedure to install the battery clip applies only to boards with the early version
battery socket.
1. Remove the top access cover. See “Removing the Top Cover” (page 142).
2. Locate the system battery or the MP battery in the battery socket.
Figure 73 Battery and Battery Socket
3. Insert the battery clip over the system battery and the MP battery on the system board.
Figure 74 Inserting the Battery Clip
Figure 75 Installed Battery Clip
184 Removing and Replacing Server Components