HP Integrity rx2660 Server User Service Guide

2. Support the power supply with both hands, and slide it into the empty slot until it clicks into
place (2).
IMPORTANT: Ensure the power supply is flush with the adjacent power supply.
Figure 15 Installing a Power Supply
Removing the Top Cover
When installing internal components into the server, you must first remove the top cover.
To remove the top cover:
1. Unlock the cover release lever (if necessary) by turning the cam approximately 90 degrees
counterclockwise with the Allen wrench provided on the rear panel of the server (1).
2. Pull up on the cover release lever to disengage the top cover from the chassis (2).
3. Slide the cover toward the rear of the server until the tabs release from the slots in the chassis
(3).
4. Lift the cover off the chassis (4).
Figure 16 Removing the Top Cover
46 Installing the Server