Manualshelf

HP Integrity rx2660 Server User Service Guide

ManualsBrandsHP ManualsServerHP Integrity rx2660 Dual Processor Server
71727374757677787980
2. Press the power button to start the server.
3. Start the operating system. For more information, see the operating system documentation.)
Powering Off the Server
Power off the server using the following methods if the server is in the standby or full power state:
• iLO 2 MP PC command
• Power button
Powering Off the Server Using the iLO 2 MP
To power off the server using the iLO 2 MP:
1. Gracefully shut down the operating system. See the operating system documentation for more
information.
2. Initiate a console session, and access the MP Main Menu.
3. Enter CM to enable command mode.
4. Enter PC to use the remote power control command.
5. Enter OFF to power off the server, and enter YES when prompted to confirm the action.
CAUTION: The main DC voltage is now removed from the system; however, AC voltage for
standby power is still present in the server.
6. Unplug all power cables from the receptacles on the rear panel of the server.
Powering Off the Server Manually
To manually power off the server:
1. Gracefully shut down the operating system. For more information, see the operating system
documentation.
2. Press the power button to power off the server.
CAUTION: The main DC voltage is now removed from the system; however, AC voltage for
standby power is still present in the server.
3. Unplug all power cables from the receptacles on the rear panel of the server.
Verifying Installed Components In the Server
This section describes how to verify that the components installed in the server are recognized by
the server.
Use the following procedure to verify that the components you have installed into the server are
recognized by the server.
NOTE: The processor cache information in the Processor Module Information below shows the
L3 Cache Size per logical CPU. Since there are two logical CPUs per processor (dual-core), a
reading of 6 MB for the L3 cache means that the cache size is 12 MB.
1. Select EFI Boot Option from the EFI Boot Manager menu.
2. Wait for the EFI Shell prompt to appear.
78 Installing the Server