HP Integrity rx2660 Server User Service Guide

Press Any Key to interrupt Autoboot
\efi\hpux\AUTO ==> boot vmunix
Seconds left till autoboot - 9
[User Types A Key to Stop the HP-UX Boot Process and Access the HPUX.EFI Loader ]
Type ’help’ for help
HPUX>
5. At the HPUX.EFI interface (the HP-UX Boot Loader HPUX> prompt), enter the boot -is
vmunix command to boot HP-UX (the /stand/vmunix kernel) in single-user (-is) mode.
NOTE: Due to the type of server you purchased, your sysset output might not exactly
match the output shown here.
HPUX> boot -is vmunix
> System Memory = 4063 MB
loading section 0
................................................... (complete)
loading section 1
........ (complete)
loading symbol table
loading System Directory(boot.sys) to MFS
....
loading MFSFILES Directory(bootfs) to MFS
......
Launching /stand/vmunix
SIZE: Text:25953K + Data:3715K + BSS:3637K = Total:33306K
Console is on a Serial Device
Booting kernel...
6. Exit the server console and iLO 2 MP interfaces when finished using them.
• To exit the system console and return to the iLO 2 MP Main Menu, enter Ctrl-B.
• To exit the iLO 2 MP, enter X at the iLO 2 MP Main Menu.
Booting HP-UX in LVM Maintenance Mode
From the EFI Shell environment, boot in LVM-maintenance mode by stopping the boot process at
the HPUX.EFI interface (the HP-UX Boot Loader HPUX> prompt), and entering the boot -lm
vmunix command.
Use the following procedure to boot HP-UX in Logical Volume Management (LVM) maintenance
mode.
1. Access the EFI Shell environment for the system on which you want to boot HP-UX in
LVM-maintenance mode.
Log in to the iLO 2 MP and enter CO to choose the system console.
When accessing the console, confirm that you are at the EFI Boot Manager Menu. If you are
at another EFI menu, choose Exit from the submenus until you return to the screen with the
EFI Boot Manager heading.
From the EFI Boot Manager menu, choose EFI Shell to access the EFI Shell environment.
2. Access the EFI System Partition (fsX: where X is the file system number) for the device from
which you want to boot HP-UX.
3. When accessing the EFI System Partition for the desired boot device, issue the HPUX command
to initiate the \EFI\HPUX\HPUX.EFI loader on the device you are accessing.
4. Type any key within the 10 seconds given for interrupting the HP-UX boot process. This stops
the boot process at the HPUX.EFI interface (the HP-UX Boot Loader prompt, HPUX>).
5. At the HPUX.EFI interface, enter the boot -lm vmunix command to boot HP-UX (the
/stand/vmunixkernel) in LVM-maintenance (-lm) mode.
Booting and Shutting Down HP-UX 91