Installation Guide - HP AD397A rx2660 SAS Smart Array P400 Controller

Installing the SAS Smart Array P400 Controller
Checking and Updating Smart Array P400 Controller Firmware
Chapter 1
17
Step 4. Locate the cdrom entry in the list of mapped devices, and change to the device by typing its
associated fs number (for example, fs0) under EFI Shell prompt.
Step 5. If the EFI utility and firmware image files are not located in the root directory, move to the
directory in which these files are located, for example:
fs0:\>cd \EFI\HP\TOOLS\IO_CARDS\SmartArray
IMPORTANT Both saupdate.efi and the firmware image file must be located in the same directory. If they
are not, copy them both to the EFI partition. Run the saupdate.efi using the fs0:\>
saupdate command.
• If you are not using the Offline Diagnostic CD:
Step 1. Download the SA EFI update utility saupdate.efi and copy it to the EFI partition.
Step 2. Download the firmware and copy it to the EFI partition.
Step 3. Boot the system to the EFI Shell and change directories to the EFI partition.
• When you are ready to run saupdate, use saupdate UPDATE to update the firmware on the Smart Array
P400 Controller.
The syntax of the saupdate UPDATE command is as follows:
saupdate UPDATE [<seg:bus:dev:func>] [smartarray_firmware_file]
For example, to update the controller at segment 0, bus 52, device 0, function 0 from the example output
above:
fs0:\> saupdate UPDATE 0:52:0:0 SPAWNxxxyyy.PAK
Replace SPAWNxxxyyy.PAK with the name of your firmware file.
For example:
fs0:\EFI\TOOLS> saupdate update 0:52:0:0 SPAWN208242.PAK
********************************************************************************
Smart Array Offline Firmware Update Utility
Version 2.06.10.03
(C) Copyright 2006 Hewlett-Packard Development Company, L.P.
********************************************************************************
Updating controller in Seg: 0, Bus: 52, Dev: 0, Func: 0
Current firmware version 2.06
Percentage completed: 100%
Activating firmware now, this may take several minutes.
Resetting and reinitializing controller.
Retrieving firmware version, this may take several minutes.
Current controller firmware version is 2.08.