Installation Guide - HP AD397A rx2660 SAS Smart Array P400 Controller

Installing the SAS Smart Array P400 Controller

Installing the Smart Array Controller

Chapter 1

Powering Off the Server Manually

To manually power off the server, follow these steps:

Step 1. Gracefully shut down the operating system.

Step 2. Press the power button to power off the server.

CAUTION The main DC voltage is now removed from the system; however, AC voltage for

standby power is still present in the server.

Step 3. Unplug all power cables from the receptacles on the rear panel of the server.

Extending the Server from the Rack

NOTE Ensure that there is enough area (approximately 1.5 meters [4.5 ft.]) to fully extend the server

from the front of the rack to work on it.

To extend the server from the rack, follow these steps:

Step 1. Flip out the two pull handles located on both ends of the front bezel. This allows the server to slide

out of the rack.

Step 2. Slowly pull the server forward by the handles until it is fully extended.

NOTE The server is fully extended when the rail clips are locked in place and the top cover

is completely accessible.

Figure 1-1 Extending the Server from the Rack

Flip handle down to slide

the server out of the rack

Flip handle down to slide

the server out of the rack