Installation Guide - HP AD397A rx2660 SAS Smart Array P400 Controller

Installing the SAS Smart Array P400 Controller
Installing the Smart Array Controller
Chapter 1
9
Figure 1-3 Removing the I/O Backplane Card Cage
Step 2. Lift the assembly straight up and out of the server.
Step 3. Disconnect the SAS cables connected to the system board, and remove the cables from the two
routing clips on the server chassis. See Figure 1-4.
Step 4. Route the cables through the unused clip against the server chassis back panel.
Figure 1-4 SAS Cables Connected to the System Board
Captive screws
Front of server
B
A
Integrated SAS cable-routing clips
Clip for new SAS
cable routing