Installation Guide, Third Edition - HP Integrity rx2660 Server

Installation Sequence and Checklist

Table 1-1 lists the server installation steps. Follow these steps in sequence to complete a successful

installation.

Table 1-1 Installation Sequence Checklist

CompletedDescriptionStep

Unpack and inspect the server shipping container. Inventory the contents using the packing

slip.

Install any additional components shipped with the server.2

Install the server into a rack or pedestal.3

Connect cables to the server.4

a: Connect ac input power cable.

b: Connect LAN core I/O cable.

Connect and set up the console for access.5

Power on the server.6

Access the console.7

Verify components in the server.8

Boot the operating system.

NOTE: For information on the operating system, see the HP Integrity rx2660 User Service

Guide or your operating system documentation.

Verify the server configuration.10

Unpacking and Inspecting the Server

This section describes procedures you perform before installation. Ensure that you have adequately

prepared your environment for the new server, received the components that you ordered, and

verified that the server and its containers are in good condition after shipment.

This section addresses the following topics:

• “Verifying Site Preparation” (page 14)

• “Inspecting the Shipping Containers for Damage” (page 15)

• “Unpacking the Server” (page 15)

• “Checking the Inventory” (page 15)

• “Returning Damaged Equipment” (page 15)

• “Unloading the Server With a Lifter” (page 15)

Verifying Site Preparation

Verifying site preparation is an essential factor of a successful server installation, and includes

the following tasks:

• Gather LAN information. The IP addresses for the iLO 2 MP LAN and the system LAN are

located on the right side of the server near the bezel, above the rack mounting rail.

• Establish a method to connect to the server console.

• Verify electrical requirements. Ensure that grounding specifications and power requirements

are met.

• Validate server physical space requirements.

• Confirm environmental requirements.

14 Installing the Server