HP Integrity rx2660 Server User Service Guide

Figure 70 Power Supply Housing Removed From the Server
21
Guide tabsCaptive screws
Replacing the Power Supply Housing
To replace the power supply housing:
1. Insert the tabs on the power supply housing into the server guide slots and align the BPS riser
board with the connector on the system board. Set the power supply housing into place.
2. Tighten the three captive screws.
a. Press the black knob down while turning it clockwise until it is fully tightened.
b. While holding the black knob and pressing down, press and release the blue button to
lower the black knob to the locked position.
3. Replace the top cover. See “Replacing the Top Cover” (page 142).
4. If rack mounted, slide the server completely into the rack. See “Inserting the Server into the
Rack” (page 141).
5. Reconnect the power cables and power on the server. See “Powering On and Powering Off
the Server” (page 77).
Removing and Replacing the Power Supply Housing 179