HP Integrity rx2660 Server User Service Guide

Table 8 iLO 2 MP LAN Link Status LEDs
LED StateLink Status
Blinking greenActivity
Steady greenLink with no activity
OffNo link
iLO 2 MP Status LEDs
Table 9 iLO 2 MP Status LEDs
LED StateiLO 2 MP Status LED
Flashing greeniLO 2 MP heartbeat
Off: The LED is steady amber when AC power is applied. It remains
steady amber for a few seconds until the iLO 2 MP completes its self-test;
then the LED turns off.
iLO 2 MP self-test
Flashing greenBMC heartbeat
Steady greenStandby power
System LAN
The system LAN functionality is integrated into the system board. The following describes the system
LAN ports:
• Two RJ-45 style 10 Base-T/100 Base-T/1000 Base-T system LAN ports.
Table 10 System LAN Link Status LEDs
LED StateLink Status
Blinking greenActivity
Steady greenLink with no activity
OffNo link
Table 11 System LAN Link Speed LEDs
LED StateLink Status
Steady orange1000 Mb
Steady green100 Mb
Off10 Mb
Power Supply
The server is equipped with one or two power supplies, labeled PS1 and PS2. Each power supply
has an AC input receptacle and an LED that shows the power state of the server. See Figure 10
(page 31) for the LED location.
The server has three power states: standby power, full power, and off. To achieve the standby
power state, plug the power cord into the appropriate receptacle at the rear of the server. To
achieve full power, plug the power cord into the appropriate receptacle, and either push the power
button or enter the iLO 2 MP PC command. In the off state, power cords are not connected to a
power source. For more information on power states, see “Power States” (page 77).
Controls, Ports, and LEDs 33