HP Integrity rx2660 Server User Service Guide

5. Lock the cover release lever (if necessary) by turning the cam approximately 90 degrees
clockwise.
Figure 31 Replacing the Top Cover
Installing the Server into a Rack or Pedestal
This section provides instructions on how to install the server into a rack or a pedestal.
Installing the Server into a Rack
The following sections describe how to install the server into an HP rack or an approved non-HP
rack.
HP Rack
HP servers that are installed into racks are shipped with equipment mounting slides. An installation
guide comes with each set of slides: HP 2U Quick Deploy Rail System Installation Instructions for
HP Products. Follow the steps in this installation guide to determine where and how to install the
server into the rack.
Non-HP Rack
The Mounting in non-HP racks guide enables you to evaluate the installation of HP equipment into
non-HP racks. Use this guide when you need to qualify whether you can install, maintain, and
service any HP equipment in a non-HP rack.
The guide is located on the HP website at: http://www.hp.com/racksolutions on the HP Integrity
and HP 9000 Servers infrastructure page. Click the Rack Systems/E link.
Select Mounting information from the menu, then select the guide titled Mounting in non-HP racks.
Installing the Server into a Pedestal
The server ships with a pedestal mount if you order the rackless configuration option. The pedestal
mount is packaged in a separate carton which is attached to the server carton.
62 Installing the Server