Installation Guide - HP AD397A rx2660 SAS Smart Array P400 Controller

Installing the SAS Smart Array P400 Controller
Installing the Smart Array Controller
Chapter 1
10
Step 5. Check that the cables are routed around the I/O backplane card cage connector, so that they will not
be pinched when the backplane assembly is re-installed.
Figure 1-5 SAS Cables Connected to the System Board
Installing the SAS Smart Array and PCI-e Expansion Cards
The rx2660 server has two slots dedicated for the SAS Smart Array P400 controller and PCI-e expansion
cards. If you purchase the RAID option, you must install these cards on the system board. See Figure 1-6 for
the slot locations on the system board.
Installing the PCI-e Expansion Card
To install the PCI-e expansion card into the server, follow these steps:
Step 1. Pinch the card locking guides to expose the slot guides to the system board slot (1). See Figure 1-6.
Step 2. Guide the PCI-e expansion board down the rails and push into the slot on the system board (2).
NOTE The board and slot are keyed, so the board only fits one way into the slot.
SAS cable routed
around I/O backplane
card cage connector