Installation Guide - HP AD397A rx2660 SAS Smart Array P400 Controller

Installing the SAS Smart Array P400 Controller

Installing the Smart Array Controller

Chapter 1

Removing the Top Cover

When installing internal components into the server, you must first remove the top cover. To remove the top

cover, follow these steps:

Step 1. Unlock the cover release lever (if necessary) by turning the cam approximately 90 degrees

counterclockwise with the allen wrench provided on the rear panel of the server (1).

Step 2. Pull up on the cover release lever to disengage the top cover from the chassis (2). See Figure 1-2.

Figure 1-2 Removing the Top Cover

Step 3. Slide the cover toward the rear of the server until the tabs release from the slots in the chassis (3).

Step 4. Lift the cover off the chassis (4).

Removing the I/O Backplane Card Cage from the Server

To access the SAS cables in your server, you must first remove the I/O backplane card cage from the system

board.

To remove the I/O backplane card cage, follow these steps:

Step 1. Loosen the two captive screws. Follow these steps to loosen the captive screws:

a. Press the blue button to release the black knob. See Figure 1-3.

b. Turn the black knob counterclockwise until the captive screw is free from the server.