Installation Guide, Third Edition - HP Integrity rx2660 Server

5. Lock the cover release lever (if necessary) by turning the cam approximately 90 degrees
clockwise.
Figure 1-20 shows how to replace the top cover.
Figure 1-20 Replacing the Top Cover
Installing the Server into a Rack or Pedestal
This section provides instructions on how to install the server into a rack or a pedestal.
Installing the Server into a Rack
The following sections describe how to install the server into an HP rack or an approved non-HP
rack.
HP Rack
HP servers that are installed into racks are shipped with equipment mounting slides. An
installation guide comes with each set of slides: HP 2U Quick Deploy Rail System Installation
Instructions for HP Products. Follow the steps in this installation guide to determine where and
how to install the server into the rack.
Non-HP Rack
The Mounting in non-HP racks guide enables you to evaluate the installation of HP equipment
into non-HP racks. Use this guide when you need to qualify whether you can install, maintain,
and service any HP equipment in a non-HP rack.
The guide is located on the HP website at: http://www.hp.com/racksolutions on the HP
Integrity and HP 9000 Servers infrastructure page. Click the Rack Systems/E link.
Select Mounting information from the menu, then select the guide titled Mounting in non-HP
racks.
Installing the Server Into a Pedestal
The server ships with a pedestal mount if you order the rackless configuration option. The
pedestal mount is packaged in a separate carton which is attached to the server carton.
36 Installing the Server