Installation Guide, Third Edition - HP Integrity rx2660 Server

Powering Off the Server Manually
To manually power off the server, follow these steps:
1. Gracefully shut down the operating system. For information on how to shut down the
operating system, see the HP Integrity rx2660 User Service Guide or your operating system
documentation.
2. Press the Power button to power off the server.
CAUTION: The main dc voltage is now removed from the system; however, ac voltage for
standby power is still present in the server.
3. Unplug all power cables from the receptacles on the rear panel of the server.
Verifying Installed Components In the Server
This section describes how to verify that the components installed in the server are recognized
by the server.
Use the following procedure to verify that the components you have installed into the rx2660
server are recognized by the server.
NOTE: The processor cache information in the Processor Module Information below shows
the L3 Cache Size per logical CPU. Since there are two logical CPUs per processor (dual-core),
a reading of 6 MB for the L3 cache means that the cache size is 12 MB.
1. Select EFI Boot Option from the EFI Boot Manager menu.
2. Wait for the EFI Shell prompt to display.
52 Installing the Server