SmartSetup Scripting Toolkit Administrator's Guide
Table Of Contents
- SmartSetup Scripting Toolkit Administrator's Guide
- Contents
- 1 Overview
- 2 Creating an SSTK boot image
- 3 Configuring an SSTK action
- 4 Booting the server
- 5 Advanced topics
- 6 Utilities reference
- 7 Support and other resources
- A Support Matrix
Table 4 hpacuscripting Error Codes (continued)
ReasonMessageWarning
Code
The preferred path specified is not a valid chassis slot for an
available active controller, or the controller is not available.
Invalid Preferred Path2865
—Failure opening capture file
text
2866
—Failure opening input file
text
2867
—Failure opening error file
text
2868
ACU found no drives that can be used as spares for the specified
array.
There are no suitable spares
available
2877
—Invalid Drive Type Specified2880
The specified value for MNP delay is invalid.Invalid MNP delay2882
The value of the option supplied to this parameter is invalid.Invalid Option3000
The controller returned an error for a command.Command Failed3002
ACU is unable to delete the license key.License Key Delete Failed3003
—Invalid Sector Size3004
—Cannot delete Array3005
—Invalid Number of Parity
Groups
3006
—Chassis name is too long3007
Another controller is already using the entered chassis name.Chassis name is already in
use
3008
The Auto Configure mode was unable to complete auto
configuration
Auto Configure failed3009
—Cannot extend logical drive,
not enough free space for
the requested size
3010
—Cannot extend logical drive,
requested size is too small
3011
The input file cannot specify both a SIZE and SHRINKSIZE
parameter.
Cannot specify both SIZE and
SHRINKSIZE
3012
The array shrink operation was not successful.Cannot shrink Array3013
The array move operation was not successful.Cannot move Array3014
The requested operation requires a valid license key to be entered.Invalid operation - Advanced
Pack support required
3015
When in Reconfigure mode, the requested spare drives must be
specified by their addresses. A simple count cannot be used.
Spare drives cannot be
specified by a count in
Reconfigure mode
3016
When in Reconfigure mode, the requested data drives must be
specified by their addresses. A simple count cannot be used.
Disk drives cannot be
specified by a count in
Reconfigure mode
3017
—Invalid number of physical
disks
3018
hpacuscripting 41