HP Carrier-Grade rx2800 i2 Server DC Solution Installation Guide
Figure 1 Rear panel components
17
NIC 2 connector
9
Power supply 2 power
connector
1
PCI 5
2 18
PCI 6 iLO 3 physical presence
pinhole button
10
Power supply 1
3
PCI 4
19
Serial connector
11
Power supply 1 LED
4
PCI 2
2012
iLO 3 connectorPower supply 1 power
connector
5
PCI 3
21
NIC 3 connector
6
PCI 1
13
UID LED button
22
NIC 4 connector
7
Power supply 2
14
USB connectors (2)
23
NIC link LED
8
Power supply 2 LED
15
Video connector
24
NIC activity LED
16
NIC 1 connector
Applying standby power to the server
1. Plug the power cords into the receptacle in the power supplies.
2. Plug the other end of the power cords into a DC outlet.
NOTE: The LED on the power supply does not illuminate in the standby power state. The
LED is green when the server is powered on to full power.
If the power restore feature is set to Always On through the iLO 3 MP PR command, the server
automatically powers on to the full power state when the power cord is plugged into the server.
Connecting to the LAN
The server has four LAN ports that provide network connectivity. Figure 1 (page 13) shows the
available LAN ports for the server.
1. Obtain valid IP addresses for each LAN port you plan to activate.
2. Connect the LAN cable from an available LAN port into a live connection on the network.
Connecting the cables 13